Hiya everyone,
My Story so far:
I posted on another forum for help on getting my TM-6900HD Super+ working again as it had been used as a freeview box only for the last year or more, because I lost all sat stuff, the dish motor had pointed to extreme west - my back door :Biggrin2: and would not move.
I only had one reply and was recommended this forum for all TM help sooo here I am.
I was also advised that I need to learn how to walk before I tried to run - just be patient and you will get there - well, you are right:Biggrin2:
I did suspect the cable and rigged up a temp, I had today off work (it was planned) and I managed to re-route the cable to a permanent fixing. it is working now, just need to learn how to use it, so I'll slow down to a walk for a while :Laugh:
My kit:
80cm motorised dish with Technomate motor;
Technomate T6900HD Combo Super +
Duolabs CAS Interface 2
Diablo Lite, that I have never been able to do anything with
GBSAT C120
Clarke Tech Editor Studio for creating editing a decent channel list.
My problems (for a start)
It has been quite awhile since I applied a patch, I just downloaded the phantom patch and there were two files, do I install them both?
I also downloaded SoftcamAll - what is softcam do I need to install that?
I installed Underworld 1.87 some time ago. can't remember what this is/does.
Is there a glossary for Satellite terms anywhere?
Well thats it, I'd be grateful for any help
My Story so far:
I posted on another forum for help on getting my TM-6900HD Super+ working again as it had been used as a freeview box only for the last year or more, because I lost all sat stuff, the dish motor had pointed to extreme west - my back door :Biggrin2: and would not move.
I only had one reply and was recommended this forum for all TM help sooo here I am.
I was also advised that I need to learn how to walk before I tried to run - just be patient and you will get there - well, you are right:Biggrin2:
I did suspect the cable and rigged up a temp, I had today off work (it was planned) and I managed to re-route the cable to a permanent fixing. it is working now, just need to learn how to use it, so I'll slow down to a walk for a while :Laugh:
My kit:
80cm motorised dish with Technomate motor;
Technomate T6900HD Combo Super +
Duolabs CAS Interface 2
Diablo Lite, that I have never been able to do anything with
GBSAT C120
Clarke Tech Editor Studio for creating editing a decent channel list.
My problems (for a start)
It has been quite awhile since I applied a patch, I just downloaded the phantom patch and there were two files, do I install them both?
I also downloaded SoftcamAll - what is softcam do I need to install that?
I installed Underworld 1.87 some time ago. can't remember what this is/does.
Is there a glossary for Satellite terms anywhere?
Well thats it, I'd be grateful for any help