What chipset drivers are you using ?
And you have removed the jumoer from the cypress board and you have installed NETFRAMEWORK 3.5 THEN NET FRAMEWORK 4 ?
yes already done
I don't know why i didn't have this f* connect message lol
some additional info :
- vuplus solo v 1.4 (lonrisun)
- timebomb by openpli 4
picture from motherboard jtag :
View attachment 94191
I think you have your wiring incorrect PZ02 should be 3.3v you have that running to ground.
I think you have your wiring incorrect PZ02 should be 3.3v you have that running to ground.
I think you have your wiring incorrect PZ02 should be 3.3v you have that running to ground.
any idea ?
please can you take a picture from your vu solo like this one, just to compare my jtag pins
View attachment 94290
Ive never jtagged mine its an original, ive jtagged a couple of Ferrari boxes recently and the connection were as follows
PZ02 3.3v you can try leaving this off though a the dev board gets its power of the USB port.
Pin next to it BSC_SCL
Pin next to it BCS_SDA If you dont get connection try switching these 2 around
Far pin is ground
Do idea what the problem is other than the clone board is dead.
We use essential cookies to make this site work, and optional cookies to enhance your experience.