VU+ Solo Red ligh Jtag vuplus V1.4
- Thread starter spooli
- Start date
What chipset drivers are you using ?
I use Bcm97325 for vu+ solo
OK so you have the correct chipset driver. Did XP pick up and install the windows driver for the cypress board ?
Try switching round the sda & scl cable at the cypress board.
Try switching round the sda & scl cable at the cypress board.
And you have removed the jumoer from the cypress board and you have installed NETFRAMEWORK 3.5 THEN NET FRAMEWORK 4 ?
yes already done
I don't know why i didn't have this f* connect message lol
some additional info :
- vuplus solo v 1.4 (lonrisun)
- timebomb by openpli 4
picture from motherboard jtag :
I think you have your wiring incorrect PZ02 should be 3.3v you have that running to ground.
what did you mean ? should I switch between 3.3v and gnd ?
can you put me on my picture exact position ?
When I put the 3.3v pin on pz02 position and gnd on the last position (left)
the cable heating !!!
No we have gone through it ive jtagged a fair few of these and all i can see is we have covered what should be working.
please can you take a picture from your vu solo like this one, just to compare my jtag pins
Ive never jtagged mine its an original, ive jtagged a couple of Ferrari boxes recently and the connection were as follows
PZ02 3.3v you can try leaving this off though a the dev board gets its power of the USB port.
Pin next to it BSC_SCL
Pin next to it BCS_SDA If you dont get connection try switching these 2 around
Far pin is ground
Do idea what the problem is other than the clone board is dead.
