Port Forwarding on a Belkin Router?

[Curly]

Hiya folks
I'm doing a little project and I need to forward 2 ports on my router.
I have a Belkin F5D9230-4

If I want to forward ports 50 and 1050 both TCP and UDP, where would I put all that on my virtual servers page??
I know which ip addy I need to forward the ports on.

Thanks

Curly

 

[jaffa]

tick enable box, put it description, inbound port 50-50 for the 1st one.

do the same for No.2 but use 1050-1050 for inbound port.

 

[karym6]

Put the port numbers in the inbound and private port and then add your IP address. You will need one entry type.

 

[Curly]

Ahh, so I need to do it in all the boxes then??

 

[jaffa]

Yes m8, you dont have to do the private one if you dont want to but I always did. same port number along the one line so you should have port 50 four times on top line

Then use a different line for the 2nd one. see wee image below, there may also be a drop down on the tcp which allows tcp/udp

 

[Curly]

Thanks a lot guys :Clap:
Yeah there is a drop down box for UDP.

Curly

 

[skinz]

theres a step by step guide to port forwarding with screen shots for most routers at portforwardingdotcom