Read Large: Processor Running (41:0C)

[Speedy2206]

Been trying to use jtag with this box for ages now and it's doing my head in! Connected it all up using JTAG from TMC and opened up OCD commander. But it wont accept the commands because it gives me the "Read Large: Processor Running (41:0C)" message. Checked all wiring and everything is OK... (double checked, and checked again!) Box just doesnt want to co-operate with me.

The software on the box is 3_1_1 something, I notice in the tutorials that the version used is 3_2_2 something. Does this have an effect?

I have cut talkback, shorted battery, and set pin. I just cant set the NETID because of the Processor Running message. I am very frustrated! Plz help!


NOTE: Forgot to mention, I get similar messages when using Samsung Debug Tool (SDT).

 

[Shonk]

not sure what it is mate
but have your tried changeing your paralell port settings in pc bios
to ecp or epp or standard or something

might help

 

[davidh]

r u putting the sammy into debug mode?
boot up wait till it shows 20 and hold in the channel down button for about 5 sec's
let go now try it

if it is a pace box put into engineers menu then try