- Joined
- Jan 16, 2006
- Messages
- 3,590
- Reaction score
- 282
Bought a solo2 se but on boot it just hangs on the blackhole screen. Wanted to flash vix anyway so tried to flash that by usb but it fails and then boots to blackhole screen again.
Thought Id try to re-flash bootloader using rs232 but it is not working. Here is what I did
run update.exe
power up receiver (screen then states it is downloading)
close down update.exe
open up hyperterminal and set settings as per pdf instructions
When I connect at this point I just get a blank page in hyperterminal. Any suggestions as to what I am doing wrong or what I can do to get this bugger flashed?
Thought Id try to re-flash bootloader using rs232 but it is not working. Here is what I did
run update.exe
power up receiver (screen then states it is downloading)
close down update.exe
open up hyperterminal and set settings as per pdf instructions
When I connect at this point I just get a blank page in hyperterminal. Any suggestions as to what I am doing wrong or what I can do to get this bugger flashed?