configuration mode

[Sammo1]

During run first time installatiion of LNBs I had the following choices

*Nothing connected
*Simple
*Loop through to: mode to make the LNB1 internally connected to the LNB2 in.
*equal to: mode to use the same configuration as that on Tuner B
*advanced:for an advanced user configuration

I don't have a moveable dish
I want to be able to have the maximum recording facilities.

I chose *advanced because I needed it to look to 28.2 degrees

Please advise: What should I have used? I have 2 LNBs connected (2 coax cables from the same LNB)

 

[Sammo1]

During run first time installatiion of LNBs I had the following choices

*Nothing connected
*Simple
*Loop through to: mode to make the LNB1 internally connected to the LNB2 in.
*equal to: mode to use the same configuration as that on Tuner B
*advanced:for an advanced user configuration

I don't have a moveable dish
I want to be able to have the maximum recording facilities.

I chose *advanced because I needed it to look to 28.2 degrees

Please advise: What should I have used? I have 2 LNBs connected (2 coax cables from the same LNB)

Any advice please, Have I used the correct configuration for my box.

 

[Ferret]

All tuner configs under Menu-Setup-Service Searching -Tuner config need to be setup the same

Simple
Single
28E

 

[Sammo1]

Did this the 2 tuners are working fine I get free to air channels no probs.
Anything else is another story