Here's the whole story :
Ive got a SB5100, That I upgraded the Firmware, using an homemade cable. (Simpliest cable ever, No resistors, Nothing, Just plain connections.)
Here's a Pic of the outside of the box, Showing the Jtag going out and joining my DB25 Connector.
As you can see, It's pretty good looking. Now let's go inside ...
As you can see, I soldered 6 cables direcly on the pins, and used a resistor pin that I cutted, To solder on all the Ground pins and link to port 22-23-24-25 of the DB25 connector (Parallel). I drilled an Hole into the metal and twisted all the cables. All the other connections are on this Schematic :
After that, I downloaded Blackcat off this
link on Megaupload, And Used Sigma 1.6 RC4 that you can find attached down there.
Now that User got his Pictures and a Tutorial for the cable, Im asking for help. I am on Videotron, A Canadian ISP, Just like Yahoo High-Speed from Rogers Cable. Videotron uses Dynamic Configuration files, One file for each Mac. So I need to find Mac's out there, And Mac's with Extreme High Speed config So I can clone, Because those are not Metered, Bandwith wise. I dont think I should use Sigma, Ill just Flash using the Original Flash, Because I only need to clone the Mac, Sigma is kind of useless.
So, Any Idea's on how to find Mac adresses ?
And Can somebody get me attached an Hackware Firmware, They are easier, and have a Tab for Max Speed so I can use for testing the Mac's.
Thanks alot !