Samsung SMT-2100C pin setting

[Ish]

Hi m8

I have samsung SMT-2100C box in Ex C&W area. I managed to get all the channels working except sky movies and porns channels. When I go to any of this channels, it come with a screen message to press red button and enter pin.

When I press red button, it come with message Please wait, just loading. After few minute this message go away. It doesn't come with any pin entry window.

Please you help me, how I can set pin on this box to view sky movies.

many thank

 

[satto]

you have to jtag box mate with macro file to bring back the pin entry option

 

[satto]

just do a search its all here good luck

 

[xl5]

http://www.digitalworldz.co.uk/forums/showthread.php?t=124272 for the macro tut m8 for jtag search m8 loads of stuff about it

 

[justintime]

hi all,

going to try the pin fix on my sammy. i have read the tut,
can anyone tell me what state the box should be in.
is it the same as jtagging wait for ld20 hold the down button, release on ld40?
anyone help?

cheers..steve.

 

[satto]

turn off power at plug turn back on. wait for ld 20 press down channel button let go at ld 40 wait for std by light to turn green then fix jtag if your using pogo jtag try using a washing line pegg to hold it as it takes 25mins to do at your hand will kill see pic

 

[mastichick]

Hi

Exactly as above but I used a screwdriver wedged in through the vent holes.

 

[paul001]

I have tried this method to write to my Sammy 2100c but when I load the macro it keeps on saying error loading macro. I have used my owm macro file and the one provided on this site. I know the cable is conected because I use bke to test the signal. Any suggestions.

 

[pe+000+pe]

I have tried this method to write to my Sammy 2100c but when I load the macro it keeps on saying error loading macro. I have used my owm macro file and the one provided on this site. I know the cable is conected because I use bke to test the signal. Any suggestions.

I had same error message...I figured out its because box wasnt in debug mode...before running macro...if using ocd commander check status button. you will know if your box is def in debug mod..also make sure all pogo jtag legs are ligned up and touching all points properly..it may take time..and get frustrating sometimes..just keep trying...

 

[paul001]

Hi. Thanks for getting back to me. I may have found the problem. I can not set my laptops printer port to epp. I only have the option of ecp. i have been told that this will not work with wiggler. Any suggestions.