Have you downloaded the kevlar file and unzipped it to a directory?
Programming a SmartCard Using Elvis and MultiProgrammer 6
Requirements
Elvis Programmer
Blank PCB/Wafer SmartCard
Multi-Programmer 6 (programming software)
Hex files
Step 1
Connect your Elvis to your serial port and plug the power supply/PP3 battery in. Start up Multi-Programmer 6 and insert your smartcard into the card slot on the programmer and hit the auto-detect button which is located immediately below the help menu.
***Warning*** Using the auto-detect button erases the card ***Warning***
Step 2
Select the PIC16F84, right click on it and select open. Now select the hex file required to be programmed into the PIC16F84 and hit open.
Step 3
Select the 24C16, right click on it and select open. Then select the required EEPROM hex file and hit open.
Step 4
Select the card type ***le and make sure the 'Program' button is enabled
Each file to be programmed should be listed next to the appropriate chip.
Step 5
Hit the program button!
Hope this works, sorry I can't help you after tonight as i'm away for a week.