Hi,
I bought a pre configured Kryptview through a friend of a friend.
When all the channels were lost I tried to update the selected transponder and scan for the channels again. The problem I have is that when trying to enter into menu>Installation I am prompted to enter a 4 digit password
After doing a little research I then got hold of a null modem cable which connects directly to my desktop PC not via a USB to serial cable, using the software called "DownTool_0927.exe" with the firmware image "Kryptview_A780_03012011.bin" hoping that this would overwrite the settings for the existing image and therefore remove the password however each time I attempt this I get an error message saying "the downloading is not requested"
I have followed the steps ie
ensuring my baud rate for the COM port is set to 115200 (tried this and 9600)
switch off the box
select the image and click start
then power on the box
Each time I get that error message, I have tried using a different null modem cables but still no joy.
Can anyone tell me if there is a default 4 digit password I can try and also if there is something that I am doing wrong when trying to flash the box with the newer image.
System Information from the menu screen tells me the following
Date 09/09/2010
Software VersionKryptview A780 pv3.6.00
H/W Version V3.0.0
Thanks for any help
I bought a pre configured Kryptview through a friend of a friend.
When all the channels were lost I tried to update the selected transponder and scan for the channels again. The problem I have is that when trying to enter into menu>Installation I am prompted to enter a 4 digit password
After doing a little research I then got hold of a null modem cable which connects directly to my desktop PC not via a USB to serial cable, using the software called "DownTool_0927.exe" with the firmware image "Kryptview_A780_03012011.bin" hoping that this would overwrite the settings for the existing image and therefore remove the password however each time I attempt this I get an error message saying "the downloading is not requested"
I have followed the steps ie
ensuring my baud rate for the COM port is set to 115200 (tried this and 9600)
switch off the box
select the image and click start
then power on the box
Each time I get that error message, I have tried using a different null modem cables but still no joy.
Can anyone tell me if there is a default 4 digit password I can try and also if there is something that I am doing wrong when trying to flash the box with the newer image.
System Information from the menu screen tells me the following
Date 09/09/2010
Software VersionKryptview A780 pv3.6.00
H/W Version V3.0.0
Thanks for any help