After not Forwarding with my Card i wont to Dump my Boxes
so any Help is Welcome
First i want to Beginn with the Kaon NS1000 Box it is Outdated and for Study and if Mistakes Happen
it would not be so Bad like on The New Box That is Still in use
If all Works i will Try on the Kaon NS1040 Box
I Ordered all Things that are Needed some CY7C68013A and Oszilloscope for Finding Ports on the Board
all is Set only Thing that i Need is a XML for Following Flash MXIC MX25L3255DXCI 10-G
i Found the Datasheet Needed but i am not sure what are the Real Datas to Put inside MX25L3255D
Chip is BCM7358
Maybe Someone Knows What Ports to use on that Board or where i can Look
in Front of The Board there is 2 Possible Places for IC2 Connection but i Wait till Oszi is Arrived to be sure The Ground Pins i Found
on the Others i have 3V but i am not Sure if my Analyzer was wrong and wait for better Results with Oszi
Any Help or Suggestion is Welcome
so any Help is Welcome
First i want to Beginn with the Kaon NS1000 Box it is Outdated and for Study and if Mistakes Happen
it would not be so Bad like on The New Box That is Still in use
If all Works i will Try on the Kaon NS1040 Box
I Ordered all Things that are Needed some CY7C68013A and Oszilloscope for Finding Ports on the Board
all is Set only Thing that i Need is a XML for Following Flash MXIC MX25L3255DXCI 10-G
i Found the Datasheet Needed but i am not sure what are the Real Datas to Put inside MX25L3255D
Chip is BCM7358
<?xml version="1.0" encoding="utf-8"?>
<Flash maker="Macronix" name="MXIC MX25L3255DXCI10-G" type="Serial">
<Command type="Spansion" programmode="Block" maxbyte="256" addressinterface="3"/>
<ID>
<Maker maxbyte="1" offset="0x00">0xC2</Maker>
<Device maxbyte="2">
<DevId offset="0x01">0x20</DevId>
<DevId offset="0x02">0x19</DevId>
</Device>
</ID>
<Size unit="mbit">256</Size>
<Sector uniform="true" secure="false">
<MaxSector>64</MaxSector>
<Size unit="kbyte">64</Size>
</Sector>
</Flash>
Maybe Someone Knows What Ports to use on that Board or where i can Look
in Front of The Board there is 2 Possible Places for IC2 Connection but i Wait till Oszi is Arrived to be sure The Ground Pins i Found
on the Others i have 3V but i am not Sure if my Analyzer was wrong and wait for better Results with Oszi
Any Help or Suggestion is Welcome