another ambit 200 for bin or not

[john!]

hi again , im tryin to do a ambit 200 (again) flashed sigmax2_125_cracked_dump
on to it but now i cant get into
192.168.100.1:1337/
and when i run SoftJTAG i get "unhandled exeption has occurred the operation has timed out"
and in hy/terminal i get .


"Compressed Image location: 81F80000
Decompression Status: 00000000
Dcompressed Bootloader size: 00011005
BSS Initialized: [ OK ]
TMP Stack initialized: [ OK ]
Perm Stack initialized: [ OK ]
MemSize: ......................... 8M
Flash detected @0xbe000000
TCNiSO SIGMA Bootloader v2.6
Build date: May 9 2005

Location: 0xBFC10000
Firmware header Not Found!



Bypassing CRC Verifiction on Image 1...
Detected LZRW1/KH compressed image...decompressing...
Target Address: 0xFFFFFFFF
Decompressed length: 0

Executing Image 1.."

now,

can i recover this modem or is it another 1 for the bin

thanx

ps it is a

abtc chip ?

 

[papa2]

You can recover this by flashing a new bootloader onto it ,( I had to do the same)
theres a tutorial somewhere but cant remember where,
but you need a modified blackcat cable and the software and a 33ohm resistor

 

[john!]

You can recover this by flashing a new bootloader onto it ,( I had to do the same)
theres a tutorial somewhere but cant remember where,
but you need a modified blackcat cable and the software and a 33ohm resistor

not good at resistors ,thoug i have b/cat ,think i,ll throw it in bin , tried bootloader
but no joy thanx papa2

 

[mark370]

not good at resistors ,thoug i have b/cat ,think i,ll throw it in bin , tried bootloader
but no joy thanx papa2

throw it in my bin mate.

 

[john!]

throw it in my bin mate.

if i new where it was id throw the 2 of them in your bin ,done same thing with 2 of them

 

[mark370]

if you can sort them out mate ill help you get them going again if you want ?
its not that hard

 

[john!]

if you can sort them out mate ill help you get them going again if you want ?
its not that hard

just gonna bin them m8

 

[Koevoet]

Dont bin them , just get the 33ohm resistor hold it in place ( no soldering) load the bootloader with the b/cat jag takes 20 seconds or so , then re-flash it with the 232/233.

Regards