good little tip that i got of a mate aswell,from the look of my soldring on a test pc motherboard i will need a fecking roll of it lolyou could have done with some solder brad (maplins)
but if you have some old tv aerial wire remove the plastic coating and then you have the outer copper braiding, need to cut some of that away and dip it in some flux and hold it onto where you have joined the legs, and put your clean soldering iron on top and keep doing this until the copper braid sucks up the solder
i have seen pics of xbc's work, and deffo trust him you need a track repairing and/or chip installing.
got some but in the process iv manager to break the track nightmare
I would still say go for a Wiiclip for the Argon, at least you can pull it out at any point an nobody will know it was even there.
wii-clip for WIIKEY,D2CKEY,D2CPRO,ARGON,D2PRO, WASABI and DMS,D2A,D2B,D2C for wii console!
If they had these when I fitted my WiiKey I would have felt much more confident and less shakey.
We use essential cookies to make this site work, and optional cookies to enhance your experience.