CAN ANYBODY HELP PLZ
Just Trying To Program Atmels With Willem 4.5 Tsop48 From Jabs Place
Can Recognise Atmel But Writing Or Erasing Failing So Probably Not Reading Properly .printer Port Is Set In Bios To Ecp.
Using Software 0.97g
Need A Bit Of Advice
Have I Got To Tick Anything On Willem Software
Temporary Sector Unprotect Not Ticked
Fast Programming Mode Not Ticked
On Programmer Settings
Skip Write 0xff Ticked
Fast Programming Not Ticked
(aaaa.5555.aaaa..) Ticked
Offset Hex=0
Check Type=16 Bit Addition
Are These Settings Allright Or Not
DIPSWITCHES ARE SET TO ON THE 4WAY 3 IS ON
ON THE 12 WAY 2,3,5,6,8,10,12, ARE ON
DEVICE SET TO 29LV160
Thanks
Just Trying To Program Atmels With Willem 4.5 Tsop48 From Jabs Place
Can Recognise Atmel But Writing Or Erasing Failing So Probably Not Reading Properly .printer Port Is Set In Bios To Ecp.
Using Software 0.97g
Need A Bit Of Advice
Have I Got To Tick Anything On Willem Software
Temporary Sector Unprotect Not Ticked
Fast Programming Mode Not Ticked
On Programmer Settings
Skip Write 0xff Ticked
Fast Programming Not Ticked
(aaaa.5555.aaaa..) Ticked
Offset Hex=0
Check Type=16 Bit Addition
Are These Settings Allright Or Not
DIPSWITCHES ARE SET TO ON THE 4WAY 3 IS ON
ON THE 12 WAY 2,3,5,6,8,10,12, ARE ON
DEVICE SET TO 29LV160
Thanks
