openbox v8s wont clear with mgcamd but does with cccam

[jfish]

anyone had this

I have setup 2 Openbox's and with a line in mgcamd it wont clear but does so in cccam

so not sure if its a firmware issue

 

[turner brown]

I take it your using n line with cccam

 

[jfish]

I take it your using n line with cccam

yes nline

loaded the nline via usb - mgcamd doesn't clear but cccam does

may try manually adding the line to mgcamd see if that makes a difference

 

[turner brown]

so it wont load via usb using newcamd.list

 

[jfish]

so it wont load via usb using newcamd.list

it does load as in I can read the newcamd.list file via USB - can go into mgcamd settings and see the active line - just wont clear and not much debugging can be done with these boxes to see why the lines doesn't work

I can then upload via USB the cccam.cfg file to cccam and that clears.

 

[turner brown]

did it work when manually loaded as never seen any have this problem

 

[jfish]

did it work when manually loaded as never seen any have this problem

not done this yet will do so later on