No signal

Is all tuner, channel list ect set up correctly
 
Think so mate the channels are all showing but just saying no signal

go to box settings and re check tuner config,in service searching take a look at signal strength in signal finder...check connections are good..
 
What image is it, it could be ABM set for another area

Is it satellite
 
Last edited by a moderator:
36% is quite poor is there a lot of the inner copper showing beyond the connector on the cable, I find that some tuners need that extra 5-6mm to get a full signal
 
You could rewire the cable to show more of the inner copper and try that
 
mate your getting no channels as 36% is half of what you need on these boxes for a decent picture..check everything connection wise,check your sat selection is correct in the tuner settings ie its 28.2E and not 19.2E or something..
 
Most replies on here are as if this box is linux and it is not.
Your lnb settings maybe wrong they should be 9.750-10.600 Universal
Make sure if its a multisat list its on 28.2e
Make sure list is upto date.
If skybox works ok then signal is good.

What stb did you buy V8s?
 
Back
Top