i have used the ncf tool too but it's hanging on 'finalising job phase 2' ....notihng happens. when i reboot the box, i still get the 'no ca found'
Have you tired this method mate ?
1--- Connect USB cable to service slot on DM800SE/DM500HD and USB slot on Pc. Windows will then install the driver
You will notice, windows created a virtual Com Port connection to be be used ( in this case Com Port 4)
2 --- Switch Receiver off and connect Network cable Receiver and Router
3 --- Then Start SunRay- FlashUp, Tick Use Network, Fill the relevant boxes with local pc IP and Remote ip of your choose and click Connect.
Program will ask for you to Switch on the receiver.
4 -- It will then go into HTTP mode
5 -- At this stage, you open your browser and insert the remote IP shown on the 800LCD
Page will open as per bellow and then you chose the option Update Firmware.
6 --- Click Browse and navigate to your image
7 --- Chose the image and click Open
8 --- Now click Flash button
9 --- Image will start to load.