Card status ok

[JIMLCHIPIT]

Just jtagged a 2100 on 3.7

bk was a little odd but looked viable.

anyways progged card an no channels, eng menu says card status ok, would it say not paired if bk was incorrect? Input public keys manuallly also so its not that it's not updating

Thanks

 

[davidh]

Just jtagged a 2100 on 3.7

bk was a little odd but looked viable.

anyways progged card an no channels, eng menu says card status ok, would it say not paired if bk was incorrect? Input public keys manuallly also so its not that it's not updating

Thanks

only says it isnt paired if the ird is wrong
check if the keys have updated if they have the bk is wrong

 

[JIMLCHIPIT]

yeah keys updated

bloody typical, back to the jtag!

Thanks david ( i always thought not paired refered to bk + ird) every days a school day eh!

 

[matt1980]

hi mate had the same thing the outher day im c&w in the end i uses 3.7 bytes and had to do it on stream work fine wonce i done that i used bbc1 thow connected jtag up thenput bot on to stram and booted put to 101 gave the bk strait away good luck

 

[JIMLCHIPIT]

matt1980 what bytes did you use?

 

[JIMLCHIPIT]

anyone know the bytes for bke 2.2 3.7 ex c&w?

 

[Satch]

anyone know the bytes for bke 2.2 3.7 ex c&w?

HiYa,

Have you tried these Here

 

[JIMLCHIPIT]

Tried them and they didn't work

so far i have tried

0x009030c8 8
0x009285cc 8
0x008ffc38 8

 

[JIMLCHIPIT]

byte 0x009285CC worked with bke 2.2 for bk

I had forgotten to take the 8 off the end for bke 2.2.

0x20020004 - ird

Thanks for the replies and hope this helps someone else out