Morning,
OK got my cool runner and it's all installed and booted up jtag.exe and read the nands again, so have 2 folders one with
nand1 and another nand2 *still reading 2 bad blocks" (this is after using the wires direct and also 2 new QSB's)
Now if i go through the jtag tool then I get to the bit where it "flashes glitch board" the green LED goes out, then the next screen where it says "nand compare and your not going to be able to continue unless you have two matching nands" blah blah.
So I've downloaded and run "nand repair" and loaded nand 1 into source and then nand 1 as destination, it then gives me the warning of "it'll overwrite" etc. etc. So i allow it too and then if I try and load them nands back into jtag tool then it comes back with the failed blocks and of course can not continue.
So not sure what to do now as "nand repair" is telling me that it's saved them and amended them but jtag tool is still telling me that the blocks are bad.
Any ideas please I'm at a loss now.
32768 block(s) in nand image
2 non-matching block(s) found
44
34EB
Cheers
Dibbs.
If I use jtag tool to repair then i get the following message.
But if I compare them again in jtag tool i still see two bad blocks.
OK got my cool runner and it's all installed and booted up jtag.exe and read the nands again, so have 2 folders one with
nand1 and another nand2 *still reading 2 bad blocks" (this is after using the wires direct and also 2 new QSB's)
Now if i go through the jtag tool then I get to the bit where it "flashes glitch board" the green LED goes out, then the next screen where it says "nand compare and your not going to be able to continue unless you have two matching nands" blah blah.
So I've downloaded and run "nand repair" and loaded nand 1 into source and then nand 1 as destination, it then gives me the warning of "it'll overwrite" etc. etc. So i allow it too and then if I try and load them nands back into jtag tool then it comes back with the failed blocks and of course can not continue.
So not sure what to do now as "nand repair" is telling me that it's saved them and amended them but jtag tool is still telling me that the blocks are bad.
Any ideas please I'm at a loss now.
32768 block(s) in nand image
2 non-matching block(s) found
44
34EB
Cheers
Dibbs.
If I use jtag tool to repair then i get the following message.
But if I compare them again in jtag tool i still see two bad blocks.
Last edited: