Blind scan on F3/5

ou toppie

Member
Joined
Jun 11, 2016
Messages
27
Hi All, hope someone can help me with a blind scan of my Astra 28.2 E
I have tried the following:
Made sure I was on Astra with S button on remote
Menu button-Installation-blind scan
Screen then shows on l/h side a list of satellites with Astra 28.2 highlighted
On r/h side LNB Power:ON
LNB Freq;9.750/10.600
22khZ:AUTO
DiSEql:1.0(1)
TP:10.700--12.750
Pol:All
Mode:All
Step:4MHz
PRESS OKAY (highlighted)

At the bottom of the screen on the left is the red button symbol Saying Auto Navigation
F1 button symbol saying Feed Ch scan off
I tried then pressing the highlighted PRESS OK button but nothing happened
So I then exit-exit-exited out back to normal tv.

Can anyone please give me some guidance as to where I failed?
Thank you
OT
 

owen

Member ++
Joined
Jan 1, 2011
Messages
142
What you have written is correct, all you need to do is just (PRESS OK) on the remote, the next screen should come up as follows, just leave for a moment for the signal to kick in.
TOP LEFT (SCANNING)
Under that will be a white tab (INSIDE THAT) the satellite that you are scanning. next to that the Freq's (it is scanning) 3rd tab (the freq it has found channels on)
Under that the percent of the scan carried out
Hope this helps
Den
 
TEST
Top