AP:52 message

[derekbinsley]

My box has froze showing AP52 has anyone come across this?

 

[slimshady]

check your net id also weak signal seen this a few times

 

[devvo]

check your net id also weak signal seen this a few times

ye u need 2 reset ur net id m8

 

[big up]

its not set to your net id yet mate set it to your net id and it should be fine

 

[gateway2000]

I got the same problem hw can i set the net id ?

 

[darrenw]

You can set netID using a funcard. 2.1.7.2 is the latest version

 

[teg]

depends what box , 4001 should auto find you just pull the red jumper . info on box is whats needed

 

[ekwat]

I'm getting this problem also. The box only boots if you force it and then only to AP:52. It's a 4001 and should set itself but it doesn't. The frequency is incorrect and the net id shows a row of dots. I made a funcard to set net id and I set the frequency correctly. The box reboots as it should but then stays on TUNE and I can't force update nor enter eng menu without a jumper pull. Any ideas?

 

[derekbinsley]

Ill try setting the net id however iv got 2 boxes with the same prob? strange!!!

 

[redwatty]

yeah strange my 2100 does is since today.

 

[MN2005]

strip the box out, and remove the tuner. pop the silver cover and look for the central pin solder onto the board. mine was a dry solder joint. spot of solder later...( and I replaced the washer ) perfect.. no more AP52.

 

[countryboy]

same sort of thing but stops on AP:53. that the same problem