Recovering your Dreambox 800 HD SE
What You need
DreamUp Sunray for 800SE Clones:
Sunray -flashup for 800hdse 500hd - Downloads - Digitalworldz
USB to UART Bridge Virtual COM Port (VCP) driver
USB to UART Bridge Virtual COM Port (VCP) driver - Downloads - Digitalworldz
Internet Explorer/Firefox or equivalent program.
A compatible image for your 800SE Clone
Dreambox DM800SE Clone Images - Downloads - Digitalworldz
Second Stage Boot Loader ssl84b
sim2_800SE_SSL84B - Downloads - Digitalworldz
A USB-A to Mini USB -B Cable
A Patch Network Cable
Download the files above.
Connect your cables to your Dreambox only and turn your box off at the rocker switch at the rear.
1 Install the USB to UART Bridge Virtual COM Port (VCP) driver
2) Plug the USB cable and the Network Cable into your computer
3 Run DreamUp Sunray program
Your COM Port should show up automatically.
Check the Network box.
Type in your PC's IP Address.
Type in an IP Address for your Dreambox. (It should be similar to your PC's IP adress e.g. 192.168.1.xxx)
Click on "Connect
Box is in Networked HTTP Mode" and your box type will also be displayed
Turn on your Dreambox
It will load and show you the IP Address for your box
Open Internet Explorer and type the IP Address from your Dreambox into the address bar
You will now be in the Boot Loader Screen
Click on the Firmware Upgrade link at the bottom of the text
Select browse and select the nfi Image file you downloaded
Click Flash and wait about 5 minutes You will see Finished and 100%
Click on the Back button and Browse and select the Second Stage bootloader
Click Flash After a few seconds it will tell you it's Finished.
Turn off your Dreambox, Disconnect your cables and your're Finished
Turn on your Dreambox and your new image will be installed
What You need
DreamUp Sunray for 800SE Clones:
Sunray -flashup for 800hdse 500hd - Downloads - Digitalworldz
USB to UART Bridge Virtual COM Port (VCP) driver
USB to UART Bridge Virtual COM Port (VCP) driver - Downloads - Digitalworldz
Internet Explorer/Firefox or equivalent program.
A compatible image for your 800SE Clone
Dreambox DM800SE Clone Images - Downloads - Digitalworldz
Second Stage Boot Loader ssl84b
sim2_800SE_SSL84B - Downloads - Digitalworldz
A USB-A to Mini USB -B Cable
A Patch Network Cable
Download the files above.
Connect your cables to your Dreambox only and turn your box off at the rocker switch at the rear.
1 Install the USB to UART Bridge Virtual COM Port (VCP) driver
2) Plug the USB cable and the Network Cable into your computer
3 Run DreamUp Sunray program
Your COM Port should show up automatically.
Check the Network box.
Type in your PC's IP Address.
Type in an IP Address for your Dreambox. (It should be similar to your PC's IP adress e.g. 192.168.1.xxx)
Click on "Connect
Box is in Networked HTTP Mode" and your box type will also be displayed
Turn on your Dreambox
It will load and show you the IP Address for your box
Open Internet Explorer and type the IP Address from your Dreambox into the address bar
You will now be in the Boot Loader Screen
Click on the Firmware Upgrade link at the bottom of the text
Select browse and select the nfi Image file you downloaded
Click Flash and wait about 5 minutes You will see Finished and 100%
Click on the Back button and Browse and select the Second Stage bootloader
Click Flash After a few seconds it will tell you it's Finished.
Turn off your Dreambox, Disconnect your cables and your're Finished
Turn on your Dreambox and your new image will be installed
Last edited by a moderator: