oscam ymod to read nline

Hi

I am trying to get oscam ymod to read my line and connect to a cs but no lucky, from the logfile it seems to connect but does not clear the channel

all help much appreciated

I presume you have enabled newcamd protocol in your oscam.conf?

wiz569 said:

I presume you have enabled newcamd protocol in your oscam.conf?

Click to expand...

ermm not sure tbh just followed the tutorial and no mention of enabling newcamd .. let me try that

jfish said:

ermm not sure tbh just followed the tutorial and no mention of enabling newcamd .. let me try that

Click to expand...

You need newcamd protocol if using nlines,CCcam protocol for clines (but I know you know that bit )

enabled newcamd protocol still no joy

jfish said:

enabled newcamd protocol still no joy

Click to expand...

Ok you have your nline setup as a reader in oscam.server with protocol = newcamd,

You also need matching port numbers between your newcamd setting in oscam.conf and your reader in oscam.server,

I can put up samples but not till tomorrow m8

I may be mistaken, but did I not read that the location of config files for Oscam_ymod had changed. This was to prevent a clash. Easiest way to check is to use standard oscam and see if it works. I may be mistaken.

Abu Baniaz said:

I may be mistaken, but did I not read that the location of config files for Oscam_ymod had changed. This was to prevent a clash. Easiest way to check is to use standard oscam and see if it works. I may be mistaken.

Click to expand...

Actually think your right Abu, the info I'm giving at the minute is based on standard oscam,

Best bet is to run oscam in a telnet session, it will show you where its falling down

still no joy it looks like it connects but thats it nothing else.. will keep plugging away

With regards to version oscam-ymod_18.t46, as posted by Ten Below from another place

Config directory changed to /etc/tuxbox/config/ymod so it will not overwrite any existing oscam files.
Oscam.keys file location /usr/keys

Click to expand...