Unlooper question

[billyk]

The powersync is the best unlooper about no point replacing it.

Im pretty sure i broke it mate, just need to buy another one.

 

[edcase]

What can you have broke? The pot? Theyre only dirt cheap .. just replace it.

Have you tried measuring across it with a meter to see if it is broken?



Are you sure the unit is correctly flashed etc?

 

[billyk]

What can you have broke? The pot? Theyre only dirt cheap .. just replace it.

Have you tried measuring across it with a meter to see if it is broken?



Are you sure the unit is correctly flashed etc?

yea i broke the pot, i wouldn't know where to start on fixing or replacing it and if it needs soldered i couldn't do it (eyes not too good)

I had it flashed and running was just adjusting the screw on the pot when my hand slipped and it's now hanging off.

 

[Bad_Ad84]

me or various other people could fix it for you, no doubt cheaper than buying a replacement.

rs will probably sell a replacement part.

 

[billyk]

me or various other people could fix it for you, no doubt cheaper than buying a replacement.

rs will probably sell a replacement part.

what kind of price we talking about here mate ?

 

[Bad_Ad84]

I'll take a look for a suitable replacement part after the weekend.

 

[Bad_Ad84]

Bourns | Passives | Resistors, Potentiometers or Control Knobs | Resistors, Variable Trimmer | Multi Turn 10mm Cermet |3296Y-1-102LF

replacement part.

 

[edcase]

I think it needs a 5k pot (the recommended starting point to adjust from is 2.2k iirc) ... the more turns the better for finer adjustment.
I bought a 22 turn 5k cermet from craplins for about £1.50 a while back.

edc.

 

[Bad_Ad84]

The data sheet of original says The 102 Model is 1k ohm. As I have one here and looked it up