hi guys, got a bit of a problem as stated in the title i have a pace 1000 phb box in the ex C&W area and basically a message came up updating box please do not switch off the box for a few minutes or some thing along those lines so i left it and since then it keeps on updating and then rebooting and then updating again and so on. A few error messages appear on the display as shown below:
scrolling no's-PdLd- EAAS-LAIT-Err4 then reboots and starts all over again, left it for a few hours and still same.
(error message taken from this thread) as he also had the same problem:
http://www.digitalworldz.co.uk/forums/showthread.php?t=99337&highlight=err4
know after alot of reading as many people have had a similar sort of problem and the usual advice given is to remove the red jumper and try to reset, however i also came across this thread with a similar problem:
http://www.digitalworldz.co.uk/forums/showthread.php?t=135341&highlight=stuck+in+update
it refers to some red wire in the box connecting one of the feet of the atemels to the board i think or at least thats what it looks like when i opened mine and found a similar sort of situation but the atmel that the wire goes from is covered with some sort of padding as shown in the picture. Regardless it was purposed from reading the thread above that this red wire could also be stoping the box from updating. So basically im a bit confused and stuck as of what to do next all help will be appreciarted. thanks.
scrolling no's-PdLd- EAAS-LAIT-Err4 then reboots and starts all over again, left it for a few hours and still same.
(error message taken from this thread) as he also had the same problem:
http://www.digitalworldz.co.uk/forums/showthread.php?t=99337&highlight=err4
know after alot of reading as many people have had a similar sort of problem and the usual advice given is to remove the red jumper and try to reset, however i also came across this thread with a similar problem:
http://www.digitalworldz.co.uk/forums/showthread.php?t=135341&highlight=stuck+in+update
it refers to some red wire in the box connecting one of the feet of the atemels to the board i think or at least thats what it looks like when i opened mine and found a similar sort of situation but the atmel that the wire goes from is covered with some sort of padding as shown in the picture. Regardless it was purposed from reading the thread above that this red wire could also be stoping the box from updating. So basically im a bit confused and stuck as of what to do next all help will be appreciarted. thanks.