@easycome: and what you have for second ROM DNASP482 RevR??
your 016c and so on?
and why you search only bk and rsa key for N3 card?
read whole this thread please!
sti is glued protective heat-resistant sealant . you must removed this sealant on jtag side and you will be see all jtag pins is pointed to ground.. remove this pins from pcb and solder on them thin wires on the jtag
princip is the same, only you must used ftdisio based minimodule.. and JTAG can be blocked..
better for you will be desoldered flash and maked flashdump
I took desoldered the processor I identified pins according to the scheme.
I tried but no result.
there are many voltages of 3.3v and gnd.
You can help me identify correct pin of 3.3v and gnd?
I contacted the information forum, but it gets hard.
How to get a deposit if I do not have the necessary information.
Everybody says that data can not be obtained by jtag, they can forget about jtag at sti5107.
More likely to connect jtag to flash GL032A90FFIS3