Hi
I am facing a problem and i wish anyone could help.
while i was working on the key ectraction, i by mistake reveresed the power plug then it gave 3 ROD
i corrected it and when put it back together the dvd doesn't read.
checked the board and i can see no burnouts, when tried the dvd i realized that with an original and a Video DVD but nothing. it keeps spinning for a while and then it stops ( giving unreadable ).
i want to retrive the key afterwards i may try to repair the dvd drive.
my question is should i try to flush the MT1319L ?
would that be enough ? or is the firmware stored elsewhere.
Note: the dvd when plugged into pc or x360 it still sense it and the xbox is operating normally which i take as an indication that the controller is still sending the key.
Thanks
Another thing, the dvd spins, ejects and closes fine
I am facing a problem and i wish anyone could help.
while i was working on the key ectraction, i by mistake reveresed the power plug then it gave 3 ROD
i corrected it and when put it back together the dvd doesn't read.
checked the board and i can see no burnouts, when tried the dvd i realized that with an original and a Video DVD but nothing. it keeps spinning for a while and then it stops ( giving unreadable ).
i want to retrive the key afterwards i may try to repair the dvd drive.
my question is should i try to flush the MT1319L ?
would that be enough ? or is the firmware stored elsewhere.
Note: the dvd when plugged into pc or x360 it still sense it and the xbox is operating normally which i take as an indication that the controller is still sending the key.
Thanks
Another thing, the dvd spins, ejects and closes fine
Last edited by a moderator: