Thanks for that, maybe as I've set the default back to the normal and haven't OC'd the machine since going back to default, I'd prefer stability rather than a little faster....so all OK for now, I'll check the mem when I pull it apart tomorrow.
It's hard to say on the temps as when all the cores are "unlocked" then no temp programs report back the true temp of it, it's water cooled with an H60.....motherboard is 30 degrees, around the memory according to the probe is 27 ish....
Is the mem running at 500 odd? I thought it was at the 666mhz....I have defaulted back to stock with all the timings and settings.
CPU Type HexaCore AMD Phenom II X6 Black Edition 1100T
CPU Alias Thuban
CPU Stepping PH-E0
Engineering Sample No
CPUID CPU Name AMD Phenom(tm) II X6 1100T Processor
CPUID Revision 00100FA0h
CPU VID 1.3250 V
North Bridge VID 1.1500 V
As you can see when it's "un-locked" then the temps don't display....it's just the way it is with the hex cores. (so I've read) all though in brackets it reads 32 so that would tie it in line with the mother board temps and around about the ram/probe.
You have to remember though, that the fan sucks air in from the outside room, it creates a negative pressure inside the case, so 2 intakes across the H60, and 2 outlets, that way it sucks cool air over the rad and across the mother board that's probs why it's sitting quite high.....it's goers well against the grain on what you have all ways done in the past and that's extract the hot air out the back, with the water cooled H50's/H60's etc. you suck air from the room over the rad.....takes a little bit of getting used too.....but tested and it works, it's cooler rather than sucking air out from inside the machine across the rad making it hotter.
all in all, have 4 intake fans, 2 x H60, one on the front where the HDD'S are, one blowing on the graphics card, then 2 x extractor fans. sounds like a lot of fans, it is, object of the game, create negative pressure within the case, I have a speed sensor type thing that I can turn them right down (apart from the H60 of course) if i'm not rendering HDMI. etc. she's as quite as a mouse.