Honeywell alarm help

[chadda]

Honeywell security Galaxy 2-20 I have this alarm system I don't have. The code for it how do you reset it?
Thanks.

 

[MH]

Default Codes
Default User Code: 1234
Default Engineer code: 112233

 

[chadda]

Default Codes
Default User Code: 1234
Default Engineer code: 112233

Cheers m8
The prob is its a house I am renting, but the scum bags have done a runner
Leaving the house like a fookin tip and over a grand in rent which I can sing for that

The house is on a meter card which ran out setting the alarm off the battery on the alarm is now flat so I pulled the fuse and disconnected the battery
I've now topped up the card but will the alarm go off if I connect it back up ?
Like I said don't know the code number the arse holes have used ?
I did ring an alarm company they said they would have to reset the board
And will cost £80
Any advise would be great

 

[MH]

The engineers code should reset the alarm if it goes off. If the battery has gone flat you may need to replace that also.


Sent from my iPhone using fingers and thumbs!

 

[baron]

If no codes are available you will have to default it I think its like the galaxy 16 you have power down, remove the sounder tr leg then remove the 2 wires from zone 1 and fit a link of wire power the system up then use defaults
If you know the eng code you can default the user manager code in perameters
Menu 51 opt 21