pil196
Inactive User
- Joined
- May 7, 2005
- Messages
- 1,780
- Reaction score
- 12
Evening all i not been around for a bit i know...hope to spend more time here work permitting
ok enough of the sucking up i got a problem hoping some one could help me with Right the problem is that my box as fooked up good style and all i could get my hands on is a couple of 2000s ewwww i know bad start straight away.
well i got me self one of them willem programmers to be exact a willem 4.5
jabs jobby. So after some extensive research on here i sorted out the dips and jumpers ie main dip 1=off 2=off 3=on 4=off now the big one 1=off 2+3=on
4=off 5+6=on 7=off 8=on 9=off 10=on 11=off 12=on now jumpers 29f bridged
vpp bridged a18 to the pin above bridged and vpp to the next one bridged right that's the willem set up
so now i run 0.97g and select 29lv160 then click id and that gives me
0x1f atmel
0xc0 at49bv/lv16x4A
so then i read the 2 atmels and save the dumps so then i open up bke 2.2
and click on chip and in the first box under at49lv1614 i put my dump from chip one and the next one i put in the dump from chip 2 then click search
but all i get is dumps are corrupt clean legs
also i have had the reading settings in both willem and pcb
if some one could help me out on this i would be grateful or if they have a tut for this programmer that would be good to
thanks...
ok enough of the sucking up i got a problem hoping some one could help me with Right the problem is that my box as fooked up good style and all i could get my hands on is a couple of 2000s ewwww i know bad start straight away.
well i got me self one of them willem programmers to be exact a willem 4.5
jabs jobby. So after some extensive research on here i sorted out the dips and jumpers ie main dip 1=off 2=off 3=on 4=off now the big one 1=off 2+3=on
4=off 5+6=on 7=off 8=on 9=off 10=on 11=off 12=on now jumpers 29f bridged
vpp bridged a18 to the pin above bridged and vpp to the next one bridged right that's the willem set up
so now i run 0.97g and select 29lv160 then click id and that gives me
0x1f atmel
0xc0 at49bv/lv16x4A
so then i read the 2 atmels and save the dumps so then i open up bke 2.2
and click on chip and in the first box under at49lv1614 i put my dump from chip one and the next one i put in the dump from chip 2 then click search
but all i get is dumps are corrupt clean legs
also i have had the reading settings in both willem and pcb
if some one could help me out on this i would be grateful or if they have a tut for this programmer that would be good to
thanks...