Hi
Here is the software you need.
skymax is software and tsop file is your flash file needed
with the power off for the computer and the eurovox , obviously with the cover off the eurovox,*note * be careful* with not touching any thing inside the box it will be live when you switch power on to both !!connect the Jtag to both.
1. turn on power to Eurovox computer is probably already on.
2. start S*Ymax2
3. select 2MB
4. click on connect. if it says something like Jtag ini, or similar you are in !. if not go back check your Handywork !! you have done something wrong.
5. click erase, this will scrub the ROM
6.if it says Erase successful,great.
7.Click on write then the important part window will open select `all files` because the defult is rom, then select the TSOP (dont worry that it says it is a.bin file !!) this is fine, click ok and if all has gone well it will start to fLash the new ROM file, with the dwnlg shown on the LCD,should take around 5 to 10 mins. if it says the end
`Ram Fail` again dont worry,all is ok , close S*Ymax2 prog and turn off and turn on the Eurovox, if it says 0000 or 0001, you are nearly done !.
Now Flash the Eurovox with your Dnupman software it should detect the `com port `again,using the Feb 07 firmware, this is clonesafe, this again is on this forum so go find !.
if that is successful turn off the Box and carefully disconnect the Jtag. put the cover back on the box and connect back up to the TV.
* NOTE you will have connect the tv coax cable to the rear of the box (TV/VCR) because the `scart connection will not work till you have cleared data and restored Factory default on the box. so use the TV to scan for the fequency till you find the BLUE BOX !
Clear Data and Factory reset are found in menu/config/clear data,then press ok and input 1004 to get to the secret menu.
select clear DATA, ok ,are you sure ? yeah what the heck I have come this far !
Then restore factory default, select the symbol rate for your area and reset to factory default.
Turn the box off then on again,connect Scart lead if not already done, and it should now work through the scart ,
good luck every one and i take no responsibilty for any mishaps