Latest Bytes exc 3_6V Pls

[bignbold3000]

Can anyone pls help me with the latest sammy bytes for exc 3_6V Pls

thanks in advance

 

[slimshady]

u have mail m8

 

[bignbold3000]

mate tried all of the bytes you suggested, keep getting rubbish......any suggestions please???

 

[slimshady]

they should be ok i used them today no probs have u tagged it properly

what r u using to send the bytes ocd you have to do as follows

byte 0x008D6284 8 type the byte and space then the set of numbers

 

[hnj]

the one i used was just 0x008D6284

use Bke 2.2 for box key as i think its easy and quick!

hope this helps

 

[bignbold3000]

am going to re-solder the jtag and check the connections are correct and then try again, will let you all know soon

 

[bignbold3000]

re-soldered jtag onto known sammy I know the IRD and bk for this one but when I try the byte to check I get rubbish, only IRD is correct, has anyone else has this problem???

 

[bignbold3000]

finally sorted thanks to a thread by TEE 111,

Put box in debug mode m8.. hold down up + down until you see ld14.. wait till you see snd.. run mac mot.. open config 1 in bke 2.2 and check bytes (used 0x008D6284).. click connect.. you should have a valid ird and bk..

Worked, thanks all for any and all help