VU+ Solo install image
- Thread starter simjonik
- Start date
Format a usb flash drive to Fat32.
1. On the USB stick create a folder and name it vuplus inside that folder create another folder and name it solo.
2. Download the USB version of a image and unrar. Now send the boot, kernel and root file to the solo folder.
3. Insert your USB stick in the front USB port. Then on th rear of your solo press the reset button.
When the VU Solo start the standby light will be RED. You should see the led light on your USB flashing. This shows the SOLO is reading the USB stick.
After a while you'll see the LED on your USB stop flashing. When this happens it means your SOLO is been programmed from it's internal memory after reading the USB drive.
When your Standby light turns green the flashing process is over and you can remove the USB stick.
Press the reset button on the rear again and the Solo will boot into the enigma2 setup process.
1. On the USB stick create a folder and name it vuplus inside that folder create another folder and name it solo.
2. Download the USB version of a image and unrar. Now send the boot, kernel and root file to the solo folder.
3. Insert your USB stick in the front USB port. Then on th rear of your solo press the reset button.
When the VU Solo start the standby light will be RED. You should see the led light on your USB flashing. This shows the SOLO is reading the USB stick.
After a while you'll see the LED on your USB stop flashing. When this happens it means your SOLO is been programmed from it's internal memory after reading the USB drive.
When your Standby light turns green the flashing process is over and you can remove the USB stick.
Press the reset button on the rear again and the Solo will boot into the enigma2 setup process.
Help will be much appreciated.
I can't install BH 2.0.7 when the installing process finishes and the green light comes on I restart the decoder but nothing comes on, only a black screen. I tried several time but always the same.
Thanks
I can't install BH 2.0.7 when the installing process finishes and the green light comes on I restart the decoder but nothing comes on, only a black screen. I tried several time but always the same.
Thanks
Are you running a clone by any chance if so try older versions of Blackhole.
Take a look in the download section there are original and clone friendly versions in there assuming yours is a clone.
2.0.6 works fine on the Cloud iBox
coathanger1
Inactive User
- Joined
- Dec 1, 2012
- Messages
- 4
- Reaction score
- 0
Check out OpenPLI too which is great but newer versions have updated drivers which wont work with clone boxes
fireangel200111
Inactive User
- Joined
- Dec 13, 2013
- Messages
- 2
- Reaction score
- 0
That is exactly what I have.
Only black scrren and tried now over 20 different images.
The interesting bit is that the network interface is down and I got a scrren by scart, but not with hdmi.
Only black scrren and tried now over 20 different images.
The interesting bit is that the network interface is down and I got a scrren by scart, but not with hdmi.
Similar threads
