BK from NT* Card

[Sunstar]

Hi,

Is it possible to get the BK from an original NTHELL card? I have acquired a 4010 box with the original card (or can you get the BK from the engineers menu for this box?).

Thanks

TESTPRN

 

[TheDogsNutts]

ok if you can unlock the card m8.....

think you need to read some more of the tut's to get a bit more

understanding m8............

 

[Sunstar]

Hey,

I'll check them out, just wanted confirmation that it was possible.

Thanks

TESTPRN

 

[kimhthwy1958]

you'll need a t911 modded and apheonix programmer or similar m8 hope this helps

 

[KhuramG]

you'll need a t911 modded and apheonix programmer or similar m8 hope this helps

depends what's the version of the card. If it's not been in the feed for a while it might not need unlocking or it can be unlocked by software and pheonix programmer without the need of moded t911.

 

[fatblerk]

Hi,
Is it possible to get the BK from an original NTHELL card? I have acquired a 4010 box with the original card (or can you get the BK from the engineers menu for this box?).
Thanks
TESTPRN

Don't rely on getting the BK off a card (rev a82 or B0C) especially if the subscription been cancelled on it
If this is just a one off box don't bother with a glitcher, just jtag the box to get the bk and then write either a Atmega or tit2 card .........

 

[bammy]

Do you know what the card version is? If it's B0C then you'll def. need a t911 to open the card. If you're just doing a one off (and providing you can solder) it would be cheaper to buy a jtag to get the BK off a 4010

 

[Sunstar]

The Card is BOC, looks like a t911 is the way to go.

thanks

TESTPRN