We have a Pyronix Sterling 10 house alarm, it was fitted by the council about 7 years ago.
On Monday during the extreme hot weather it went off on it's own. Put the code in but it wouldn't stop, so ended up cutting the power and pulling the battery to make it stop after about 20 minutes.
Since then I have not been able to get it back on properly. It says TAMPER every time I try to set it and the alarm goes off almost immediately.
I think perhaps the hot weather has caused a component to pop or a dry joint to occur in the bell housing on the front of the house but can't tell for sure. I checked all the room sensors and they appear to be working fine, as is the door sensor, anti tamper switch in the connections box and personal attack switch so can only think it is the bell.
Has anyone ever dealt with or used one of these?
On Monday during the extreme hot weather it went off on it's own. Put the code in but it wouldn't stop, so ended up cutting the power and pulling the battery to make it stop after about 20 minutes.
Since then I have not been able to get it back on properly. It says TAMPER every time I try to set it and the alarm goes off almost immediately.
I think perhaps the hot weather has caused a component to pop or a dry joint to occur in the bell housing on the front of the house but can't tell for sure. I checked all the room sensors and they appear to be working fine, as is the door sensor, anti tamper switch in the connections box and personal attack switch so can only think it is the bell.
Has anyone ever dealt with or used one of these?