Hi Guys
I have posted this request as a reply to another thread, So sorry for posting this again, But thought I may get some help as new thread.
So here goes.
I have just bought this programmer and have this problem.
The programmer will program cards using the Infinity USB software provided via USB fine. I have managed to program,read and clone a funcard4 and read a ATMega163 without problems
But when go into phoenix mode and I try and use MultiProg 1.90 to just read the card I get the message
No Programmer Found
I have downloaded the test program for it from Ad Teknik here
[DLMURL]http://www.adteknik.se/english/download.htm[/DLMURL] Called MP Test
When I run this program it reports the same.
I have tried it on another pc and using another serial cable but the same error exists.
I am doing something wrong or was I just unlucky and got a duff one.
Any help would be thankfully received.
Cheers
Joe
I have posted this request as a reply to another thread, So sorry for posting this again, But thought I may get some help as new thread.
So here goes.
I have just bought this programmer and have this problem.
The programmer will program cards using the Infinity USB software provided via USB fine. I have managed to program,read and clone a funcard4 and read a ATMega163 without problems
But when go into phoenix mode and I try and use MultiProg 1.90 to just read the card I get the message
No Programmer Found
I have downloaded the test program for it from Ad Teknik here
[DLMURL]http://www.adteknik.se/english/download.htm[/DLMURL] Called MP Test
When I run this program it reports the same.
I have tried it on another pc and using another serial cable but the same error exists.
I am doing something wrong or was I just unlucky and got a duff one.
Any help would be thankfully received.
Cheers
Joe
Last edited by a moderator: