So I have a Vu+ Duo2, 80cm dish, 3 LNBs pointing at 13/19/28, all split up by a DiSEqC switch and a shotgun cable down the flat, so one end goes into one tuner, the other end into the next available tuner.
1. How should I configure the tuners? This is what I've used so far and it worked OK, only using one cable, one tuner, as I didn't have a HDD at the time and there was no point trying.
But I got a HDD now so naturally I would like to make the most of this.
2. I am now a bit confused, should I use/configure tuner B or tuner C? As at the back of the box, both tuners have 2 'LNB In', now which one is what?! I've tried configuring tuner B the same as tuner A with both cables at the top input on each tuner but it didn't work.
I did notice though that I could record 4 channels at the same time but all of them being BBC!
4. Lastly, how would I know if I got it right after I configure the tuners, should I check tuner B or C or whatever for signal in Main Menu / Setup / Service searching / Sat finder? Should I set up 13.2 on one tuner and 19.2 and 28.2 on the other one?
I've been searching and still do it, didn't find a guide or anything relevant, I do apologise if there's one around, but couldn't find one.
1. How should I configure the tuners? This is what I've used so far and it worked OK, only using one cable, one tuner, as I didn't have a HDD at the time and there was no point trying.
But I got a HDD now so naturally I would like to make the most of this.
2. I am now a bit confused, should I use/configure tuner B or tuner C? As at the back of the box, both tuners have 2 'LNB In', now which one is what?! I've tried configuring tuner B the same as tuner A with both cables at the top input on each tuner but it didn't work.
I did notice though that I could record 4 channels at the same time but all of them being BBC!
4. Lastly, how would I know if I got it right after I configure the tuners, should I check tuner B or C or whatever for signal in Main Menu / Setup / Service searching / Sat finder? Should I set up 13.2 on one tuner and 19.2 and 28.2 on the other one?
I've been searching and still do it, didn't find a guide or anything relevant, I do apologise if there's one around, but couldn't find one.
Last edited: