- Joined
- Jan 19, 1999
- Messages
- 32,154
- Reaction score
- 9,225
A Guide to flash your images on your Cloud Ibox3 Receiver.
I found this information
Please use at your own risk, and good luck
Regards
Mick
- Download Your Cloud Ibox3 firmware from our Downloads area:
http://www.digitalworldz.co.uk/downloads.php?do=cat&id=126 - Find the file that you have downloaded on your PC and Extract it to a destination of your choice
You will need to make sure you remember where you placed the files and what the folder was called (pay attn). - You will need to have a usb key/pen ready and make sure that you format this drive in FAT32 Mode.
- For best Results use a 4GB they are said to work well
- Copy the files over to the Usb key / pen
- Make sure your Cloud Ibox3 Receiver has been powered down and has no power on .
- Plug in your Usb pen / key containing the files into the back of the box (must be the rear).
- Make sure that there are no other folders or files are on the Usb Key/pen.
- Power up your Cloud Ibox3.
- The USB should now start transferring the files over to the Cloud Ibox3 Receiver (it is a good idea to have a flashing USB Key or Pen so you will see it happening).
- If you do not have a Flashing Pen or USB Key then leave it around 10 minutes to be on the safe side as it normally takes about 3-4 minutes to process.
- Turn off the power to the icloud ibox3 receiver from the mains!
- You now must remove the USB PenDrive or USB Key.
- And now turn on the mains to the box and power it up.
- The Cloud Ibox3 Receiver will reboot, you will see the cloud ibox3 flash screen and then it should switch on your newly installed Image.
- Depending on the Image you should now get a wizard screen that will guide you through the initial setup wizard.
- You are now ready to configure your Cloud Ibox3 Receiver how ever you want.
- Have Fun
I found this information
Please use at your own risk, and good luck
Regards
Mick
Last edited: