250 flashing error

[chrisnasah]

Hi,

I was trying to flash some modems this morning, managed to get one done back on 20 mg rums: however i had issues with one of them, not exactly sure on the exact words but hopefully you all experts might have come across it.

I reach up to a point where (from Haynes guide):

Image does not have standard header. Do you wish to store it? [n] Y (press enter)
Programming 2097152 bytes
Enter sector to start store: 0 (type 0 press enter)
The modem will now write the new firmware to the flash.

Its at this stage it fails... says fail on some i think QIR string or something, says tried it 3 times and failed? goes back to flash page to press D again.

Any ideas?

 

[chrisnasah]

here you go this is what am getting? any ideas?

.................................................. ...............
Tftp complete
Received 2097152 bytes
HCS failed on Image 0 Program Header

Image does not have standard header. Do you wish to store it? [n] y
Programming 2097152 bytes
Enter sector to start store: 0
Didn't find QRY string!
Didn't find QRY string!
flashDetect: ERROR: Flash programming FAILED: 3
ERROR: Flash programming FAILED: 3
Store parameters to flash ? [n]

 

[gentlex]

flash is failing, either because its not supported or bad flash... what chipset is on the modem