Managed to register and extract the info (below)
--------------
Finally received an answer from the service engineer. As you might expect the answer is the same great originality. The main reason boot sector corruption, he said, could serve as the use of third-party software, though I did not write them, how exactly the image I use. Consequently, for warranty repairs I can not count. Among the reasons may be related abrupt power outage, storm activity, the accumulation of static electricity and its level when the USB and SATA devices, etc. And in the end asked to share their experiences of recovery. I said I'd think about it, because it is a joint work of many, many people and I can not make a decision.
Now, as they say, let us return to our sheep, ie, brief instructions, and most likely, the exchange of experience to restore the boot sector (bootarg). And so, if you turn on the receiver and you have the receiver's display for a long time burning inscription "starting" then all that is written below
for you.
For this work, we need:
1. Computer (laptop) in which there is a serial port (SOM1-SOM. ..). Since modern laptops missing COM port I used USB-Serial Adapter firm STLab.
2. Null modem cable to connect the receiver to your computer and COM ports.
3. Terminal program, I recommend that on the advice of Wolf , used for this purpose PuTTY. You can use HyperTerminal most Windows, but I have him failed to interrupt the process startup.
4. To adjust the receiver is desirable, but not necessarily, the presence of the network between the computer and the receiver. This is the case if it attempts to recover stitched images of the new or old. If you do not do this, the network can be connected even after the restoration of the receiver.
firmware I've tried many from different manufacturers, both old and new, so I had a receiver that is called "naked" so I connected the network immediately.
And so we've put together on the computer and the receiver COM ports launched PuTTY and receiver included. If obtained in this log is as follows:
you can claim a 99% probability that you have damaged boot sector.
To restore the boot sector, but rather must be said, to boot receiver damaged boot sector must run PuTTY and in conjunction with the receiver switched on, press and hold for 3-5 seconds, press "Ctrl + C" to interrupt the startup process, and after receiving the invitation, enter the command:
, and press Enter.
And this team is missing or damaged in the internal loader receiver. Then you can continue to configure the receiver as you do it after the first turn just unpacked receiver. If you are not pierced new images, then the receiver is loaded with all your settings, and you can enjoy watching their favorite shows to ... first reboot or turn off the receiver mode "Standbay". That is, each subsequent loading of the receiver will be possible only through the terminal via the above external command.
For a complete boot repair receiver run PuTTY, turn on the receiver, hold down "Ctrl + C" and then interrupt the startup type:
and press "Enter". After executing this command, as a sign of progress will be full load receiver and an appearance on the TV screen pictures, turn off and turn on the receiver.
To confirm whether the loader restored enter the command in a terminal:
pre stopping startup method described above. If the log command executed is as follows:
I congratulate you. You have restored your receiver.
Finally I want to say thank you very much
Wolf ,
gemchug74 ,
Rolex and others for their assistance. Without their help and support this statement could not be. Although the instruction is still loudly.
Due to numerous questions about the setup program PuTTy decided to add the user manual drawing showing a configuration of the program. As they say "better to see once than hear a hundred times."