Don't know if anyone can suggest a way forward with this.....
Basically I've been using SX Pro with my Switch. It's an unpatched version. I was on firmware 6. Took a copy of my Nand before doing anything
I later updated to firmware 10.2 using ChoiDujourNXv102. But didn't take a Nand backup after this. I'm fairly sure the AutoRCM mode was on when I did the firmware update so in theory no fuses should have been burnt
Recently my switch failed, and both the PI3USB and M92T36 had blown. These were replaced, and the v6 Nand was restored because the key was wiped I believe.
However the Switch will not boot normally No problem getting into SX Pro etc. So I am assuming that there is now a fuse mismatch and it won't do anything.
Are there any options to fix this? I did spot a webpage that talks about upgradng the firmware via a PC and the PC version of ChoiDujour. Any thoughts?
Thanks!
Basically I've been using SX Pro with my Switch. It's an unpatched version. I was on firmware 6. Took a copy of my Nand before doing anything
I later updated to firmware 10.2 using ChoiDujourNXv102. But didn't take a Nand backup after this. I'm fairly sure the AutoRCM mode was on when I did the firmware update so in theory no fuses should have been burnt
Recently my switch failed, and both the PI3USB and M92T36 had blown. These were replaced, and the v6 Nand was restored because the key was wiped I believe.
However the Switch will not boot normally No problem getting into SX Pro etc. So I am assuming that there is now a fuse mismatch and it won't do anything.
Are there any options to fix this? I did spot a webpage that talks about upgradng the firmware via a PC and the PC version of ChoiDujour. Any thoughts?
Thanks!