dantis
Inactive User
I have just installed an ***** Dark Motor Superior on one of my 80cm dishes, it feeds an Openbox S10 via a 4-way Diseq switch, I have 28.2E and 26E via a fixed dish as well.
The motor is using Port 3 on the Diseq menu, 28.2E is on Port 1 and 26E on Port 2.
I have successfully set-up the following satellites, from east to west: 19.2E, 13E, 0.7W, 7W and 30W.
I have no problems with any satellites driving from west to east, however, usually I cannot go from 13E or 19.2E to 0.7W or 7W directly, the motor starts to move and just stops, the weird thing is that if I select 30W it will drive there no problem. If I am on 0.7W it will go to 7W and 30W no problem, it just seems not to like to go from 13/19.2E to 0.7/7W? I end up going to these two satellites via 30W. I should add that very occasionally, it will work, probably only about 1 in 10.
I have tried both USALS and Diseq 1.2, both the same outcome.
This is my first motorised system so I don't really know much about them, so there might be a technical reason, although I cannot fathom out what!
Any help guys?
The motor is using Port 3 on the Diseq menu, 28.2E is on Port 1 and 26E on Port 2.
I have successfully set-up the following satellites, from east to west: 19.2E, 13E, 0.7W, 7W and 30W.
I have no problems with any satellites driving from west to east, however, usually I cannot go from 13E or 19.2E to 0.7W or 7W directly, the motor starts to move and just stops, the weird thing is that if I select 30W it will drive there no problem. If I am on 0.7W it will go to 7W and 30W no problem, it just seems not to like to go from 13/19.2E to 0.7/7W? I end up going to these two satellites via 30W. I should add that very occasionally, it will work, probably only about 1 in 10.
I have tried both USALS and Diseq 1.2, both the same outcome.
This is my first motorised system so I don't really know much about them, so there might be a technical reason, although I cannot fathom out what!
Any help guys?
Last edited: