Hi All.
Well having returned from work – where I spoke to an IT bloke and he suggested I do a hard reset of the router. I thought this was rather odd as I had done a reset as mentioned in a previous post. So I did a hard reset (total reset including reinstalling all the ISP information etc) and bugger me – A now talks to B and hey presto!
I used the Sunray flash up and installed ramiMAHER-v20-dm800se-9-25-2011.nfi and off we went. Although it works I have had the dreaded green screen a couple of times when I went to install a USB for the picons and EPG so I think there might be something amiss. Just to confirm I:
1/plugged mini USB lead into box.
2/inserted earthnet cable
3/started Sunray flash up
4/powered up box
5/inserted box IP address into web browser
6/got the flash up page on screen
7/selected ramiMAHER-v20-dm800se-9-25-2011.nfi
8/installed
9/disconnected and rebooted box.
Now as I mentioned I have had a few probs with it crashing and not wanting to play with the USB. I also can’t seem to find any utility to uninstall adons on this image? Not sure if its operator trouble or if there just isn’t one.
– Here’s the question though, should I have “flashed it” again or flashed it with something else (Boot loader) after I had finished or done something else/different?
I am hoping that I have installed it correctly as it is working (of sorts) but I am concerned that when I go off to work and the box poohs itself whilst I am away her in-doors will get on her hobby horse again.
I should say that without all the help and support I have received through this forum I would have purchased a rather elaborate door stop from China – so thanks to all for replying.
Regards.
Will you be using this mainly for viewing 28.2e?
If so i would suggest reflashing it with the latest DBUK image,followed immediately by the ssl84a bootloader,
this already has most of the things you would be looking for pre installed