Dm500c & Commando 16.0

[silverdale]

How do you set up scan and autobouquets on one of these ?

 

[silverdale]

I'll rephrase the question ,

I had to reflash to get it to scan but I can't get the mgcamd to work.
I use to have a working mgcamd on my pc but that's long gone.
Anyone the correct mgcamd and mg_cfg & lib handy ?. The one I've tried doesn't work God only knows why.

 

[spud1966]

This one is a good image had the same problem way back

Commando help needed 500c

mgcamd and mg_cfg is in the image setup for cable

But see if you get a reply, will save you a bit time flashing the box again

 

[plasterer]

make sure you add libcrypto.so.0.9.7 to the image
or mgcamd wont run ...............Paul

 

[craigneuk]

I think i had another go at this later on i will see if i can find post memorys not that good
channel list
hope this helps il try later on and have another look

 

[LraiZer]

make sure you add libcrypto.so.0.9.7 to the image
or mgcamd wont run ...............Paul

No need to add any libs in C16.0, the libs are built into image from source and linked against required binaries for their symbols at build time.