Scalper100
Inactive User
- Joined
- Jun 18, 2015
- Messages
- 6
- Reaction score
- 0
I have a X Duo 2 box stuck in Red Light. I flashed it with a non clone safe image before I knew what I was doing....Rookie mistake I know. I have tried flashing through the RS232 but with no success, I have read so many posts my head is spinning.
Is this only fixable by JTAG and do I need to purchase a board and make custom leads to get this to work or is it a case I don't have the correct boatloader files or do I need to replace the flash chip?
As you can see I have read many suggestions on this.
The support for these boxes are poor so contacting the manufacture is impossible should I just write it off as a lesson learned, any help would be welcome.
Is this only fixable by JTAG and do I need to purchase a board and make custom leads to get this to work or is it a case I don't have the correct boatloader files or do I need to replace the flash chip?
As you can see I have read many suggestions on this.
The support for these boxes are poor so contacting the manufacture is impossible should I just write it off as a lesson learned, any help would be welcome.