wedgy2k
Inactive User
Hello All
I'm trying to set a netid 41042 on sammy 2100. Someone has kindly provided me with the correct macro.
When i try to connect in OCD i get the following error message
"Error Response from INITIALIZE: 0x03 initialize_target : cable disconnected (10 :"
So i'm guessing my jtag is not connected, but it works fine for SDT and BKE2.2, so cable/pins are ok.
Is there something the order that the box is powered up, software started etc?
The method i'm using i found in a post
"power the box to ld20, hold down to ld40 and wait to 0"
So i connect my jtag, start drvload and then ocd (but don't press connect) follow above but still get error message.
Still get
"Error Response from INITIALIZE: 0x03 initialize_target : cable disconnected (10 :"
I'm very frustrated now as all the posts say this is the easiest method of setting netid. I've tried funcard method and all i get is it set 65555 which means it aint worked...
Any help greatly appreciated
Cheers
I'm trying to set a netid 41042 on sammy 2100. Someone has kindly provided me with the correct macro.
When i try to connect in OCD i get the following error message
"Error Response from INITIALIZE: 0x03 initialize_target : cable disconnected (10 :"
So i'm guessing my jtag is not connected, but it works fine for SDT and BKE2.2, so cable/pins are ok.
Is there something the order that the box is powered up, software started etc?
The method i'm using i found in a post
"power the box to ld20, hold down to ld40 and wait to 0"
So i connect my jtag, start drvload and then ocd (but don't press connect) follow above but still get error message.
Still get
"Error Response from INITIALIZE: 0x03 initialize_target : cable disconnected (10 :"
I'm very frustrated now as all the posts say this is the easiest method of setting netid. I've tried funcard method and all i get is it set 65555 which means it aint worked...
Any help greatly appreciated
Cheers