"starting" and "hw error" loop and VTI 7.0.0

Hello guys,on one of the Clone boxes i hade the "starting" and "hw error" loop,i tryed everything but could not bring it back to live again!;-(

But today,i tryed it with the new VTI 7.0.0,and after flash it should give the "hw error" but it didnt it past this and got through to "Vu Solo2"
I was realy supprised and push the power off,specialy after today one of my,stupid,mates bricked his box with this image,

I downloaded a old safe image and flashed again,and...IT WORKED!!!!!I Think it worked because of the Kernel change with the VTI 7.0.0,that give the box the BOOST it was needed

Thank u VU...Thank u!!!!VU brought my half dead box back to live again with this image;-)

So for everyone with the "starting" and "hw error" loop,FIRST PUT OUT URE SAT CABLE!!!
Then Download and Flash this image: http://www.digitalworldz.co.uk/download-vu-images-581/399866-download-vti-vu-team.html

If it will start,then power it off again and put a Safe image on youre box,BECAUSE GOING THROUGH WITH THE VTI 7.0.0 WILL BRICK URE BOX!!!!


Now this box is working PERFECT again,and i hope this methode will help others also!

Good luck!!!!