reset
StBlink4 or 5 will allow you to reinstall the original Qcx bin file that was first issued with the box, i am not certain as to wether this is the actual factory reset software as i have not seen any other software offered for this box. It is a good place to start. Load the Qcf_710 Bak file with stblink through your com port (1 or 2) using a null modem cable, flash the image. Then over write the old with the new V1.04. Hopefully this will get you up and running after a scan. There was also a second image released.
CryptSilver-v1.0-TSOP48.bin" is for those who's boxes are dead ... stuck on orange light.
This dump must be flashed onto the TSOP48 using a programmer. You could also try using the 20pin JTAG
connector in the box using JKEYS if you can work out how to set that up for this box.
There is a newer version of this Tsop bin that covers the new Key roll
Best I can come up with as this box was very poorly served by the retailers/manufacturers.
I have attached the original files and stblink software it may be of some use?