Can anyone tell me the rating of the two resistors taken out for the anti update mod on this box and also where i can buy them please.
My box is on cr1 in ex c&w area and want to upgrade to cr3.2
Can anyone tell me the rating of the two resistors taken out for the anti update mod on this box and also where i can buy them please.
My box is on cr1 in ex c&w area and want to upgrade to cr3.2
One of the components is a 100nF (0.1µF) capacitor, and the other is a resistor (I think a 100 Ohm will do it but I cant be 100% sure).
IUll have a look tonight and post back.
Can anyone tell me the rating of the two resistors taken out for the anti update mod on this box and also where i can buy them please.
My box is on cr1 in ex c&w area and want to upgrade to cr3.2
Cheers for that edcase ,
I managed to find an old post by spectre indicating the same earlier 2day
Down to maplins 2morrow and i'll give it a go.
One more question if its too complicated to do(as im no expert solderer and its a delicate area) is cr1 software gonna be ok when VoD rolls out in ex c&w area or do i need to upgrade?
cheers again:Cheers:all at DW
Guys, can someone tell me.. iv got a 1000 phaze 1b and its an old NTL box in TW area, can i just do the anti-anti-update mod or will i have to flash the atmels also??
One more thing.. cane someone point me in the direction for a tut on doing the fix on the update mod.. iv looked but cannot see!! : shocked2
@Fraggle - the 1000-phase1b is the only exCW box that will roll over onto TW no problem .. arnt you lucky .. you just need to undo the no-update mod and it will switch to telewest no problem.